Gladiator GAJG36GRDG Manuale delle Istruzioni Scaricare il pdf (Pagina 5)

Install Leveling Legs

(optional)

IMPORTANT: If you are going to install the cabinet on Gladiator

GearWall

panels or GearTrack

channels, you do not need to install

leveling legs.

1. Place the cabinet on its side.

2. Screw a leveling leg (P4) into each of the four rivet nuts located at

the corners of the cabinet as shown.

3. Stand the cabinet upright.

4. If you have not already done so, fasten the two bolts at each

front corner, of the cabinet frame. Completely tighten all of the

cabinet bolts and nuts.

Install Shelves

IMPORTANT:

■ The shelves are supported by the metal slots on the cabinet

sides.

■ Make sure the magnet in the right of each long shelf edge is

facing out.

1. Place a shelf (P5mr) so that the 2 tabs in the shelf ends are

aligned with the pair of slots in the middle of the cabinet sides.

2. Tilt the shelf so that one end is higher than the other as shown.

3. Insert the shelf into the cabinet so that the higher end is directly

above the desired slots and push the shelf down into place

behind the side slots. Raise the lower end so it is directly above

the desired slots and push the shelf down.

NOTE: You may need to slightly bend the shelf tabs outward for

the tabs to engage in the slots. Make sure the shelf tabs are in

place behind all the slots, as shown.

A. Leveling legs

AAA

BBB

CCC

DDD

EEE

A. Push down.

B. Lift up.

A. Cabinet slot

B. Shelf tab

P5mr

1 2 3 4 5 6 7 8 9 10 ... 19 20

Nessun commento

Gladiator GAJG36GRDG Manuale delle Istruzioni Pagina 5